Broom Head Handle Push Fit Socket Bracket Plastic 23/24 mm
Barcode: 5055058186805
MPN: 583266
Quality hard plastic bracket,
Fixes and supports 23mm – 24mm 15/16 inch diameter broom handle poles.
Suitable for fixing to flat broomheads.
4 screw holes makes for a very strong connection.
To be used with 4.0 x 25mm or 30mm wood screws if the broom head is thick enough the longer the better.
Installation:
Line up the fitting in the middle of the broom.
Using a marker pen or pencil mark the holes.
Remove the bracket and using a bradawl mark the holes.
The brawl may be enough to penetrate the head to start the screws, if the broom head is very hard using a small drill, drill the pilot holes,
Now simply screw the bracket into place making sure that the screws are fully home.
Tip for installing a broom handle, if the broom handle is very tight, place the broom handle near a heat source to dry it out.
The broom handle tip can also be scratched firmly with the grain using an old food fork, this removes some of the wood and allows for easier insertion.
Once started, turn the broom over and tap the broom handle on the floor and the shock will force the handle into the socket.
Finally secure the handle with a thin screw.
Screw Tip:
If your hands are weak or you are not used to using screws the use of torx screws is a good option as there is very little effort needed to keep the torque screwdriver or bit in the screw making them much easier to screw home.









Reviews
There are no reviews yet.